If you've received a letter from your water utility reminding you that your annual backflow test is due, you're not alone. Backflow testing is required for many commercial properties, irrigation systems and fire sprinkler lines — and for good reason. It protects the drinking water your whole community shares.
What is backflow?
Water is supposed to flow one way: from the public supply into your building. Backflow happens when that flow reverses and water from your property's plumbing — which may contain fertilizer, chemicals, soap or bacteria — is pulled back into the public water lines.
There are two causes:
- Back-siphonage: a sudden drop in supply pressure, such as a water main break or heavy firefighting use nearby, creates a vacuum that sucks water backward.
- Backpressure: pressure on your side of the system — from a pump, boiler or elevated tank — exceeds the supply pressure and pushes water the wrong way.
Why testing is required
Backflow preventers are mechanical devices with springs, seals and check valves. Over time, debris, mineral scale and wear can keep them from closing properly — and a failed device gives no outward sign. Annual testing by a certified tester is the only way to confirm the device still works. That's why water utilities and local codes require it, and why missing a test can lead to fines or even water shutoff.
Who usually needs backflow testing?
- Restaurants, medical and dental offices, car washes, laundromats and other commercial properties
- Properties with lawn irrigation systems
- Buildings with fire sprinkler systems
- Homes with pools, boilers, or water treatment equipment connected to the plumbing
- Any property your water utility has identified as a cross-connection hazard
Requirements vary by water utility, so check your notice or call us and we'll help you understand what applies to your property.
What happens during a backflow test
A certified tester connects a calibrated test kit to the device's test ports, briefly shuts off the water, and checks that each check valve and relief valve opens and closes at the correct pressures. The test usually takes 20 to 30 minutes. Results are recorded and submitted to the water utility.
What if the device fails?
A failed test usually means a worn seal, a weak spring or debris in a check valve. Most devices can be rebuilt on the spot and retested. Older or damaged devices may need replacement. Our backflow prevention and testing service handles testing, repair, replacement and paperwork.
Protect your plumbing year-round
Backflow devices installed outdoors can crack in a hard freeze, so insulate or drain them before winter. Watch for drips from the relief valve, which can signal a problem. And because pressure problems often start elsewhere, it pays to keep the rest of your system healthy — from aging pipes to gas-fired equipment like boilers and water heaters. If a device bursts or floods, our emergency plumbers are available 24/7.
Backflow test due? Call (888) 206-2089 to schedule.