Water pouring right now? Shut off your main water valve first, then call (888) 206-2089. Our emergency plumbers answer 24/7.
A burst pipe is one of the most stressful things that can happen in a home or business. Water spreads fast, and every minute adds to the cleanup. The good news: if you know what to do in the first half hour, you can dramatically limit the damage.
Step 1: Shut off the water
Find your main shutoff valve and turn it clockwise until it stops. It's usually where the water line enters the building — on a basement wall, in a crawl space, in the garage, near the water heater or in a utility closet. In some homes it's in a box near the street. If the leak is from a single fixture, its own shutoff valve underneath may be enough.
Tip: find your main shutoff before you need it, and make sure it actually turns. Old valves often seize.
Step 2: Make the area safe
Water and electricity don't mix. If water is near outlets, appliances or the electrical panel, stay out of the area. Turn off power at the breaker only if you can reach it without standing in water.
Step 3: Drain the system
Open the lowest cold-water faucet in the building to drain remaining water out of the pipes, and flush toilets to empty the tanks. If the burst is on a hot line, turn off the water heater (power off or gas to "pilot") and close its cold-water inlet.
Step 4: Find the leak and contain it
Look for bulging ceilings, wet drywall and spreading puddles. If water is collecting in a ceiling, place a bucket underneath and carefully poke a small hole to let it drain in a controlled way rather than letting the ceiling collapse.
Step 5: Remove water and protect belongings
Move furniture, rugs, electronics and documents out of the wet area. Mop and towel up standing water. Open windows and run fans to start drying — mold can begin growing within 24 to 48 hours.
Step 6: Document everything
Take photos and video of the burst pipe, standing water and damaged items before cleanup. Keep receipts for emergency supplies, and call your insurance company as soon as possible.
Step 7: Get a professional repair
Tape and clamps can buy a little time, but a burst pipe needs a proper repair. A plumber will cut out the damaged section, replace it and pressure-test the line. If the pipe burst because of widespread corrosion or old galvanized or polybutylene pipe, pipe replacement or repiping may prevent the next one.
Why pipes burst
- Freezing: water expands as it freezes, splitting pipes in exterior walls, attics, garages and crawl spaces.
- Corrosion: older steel and copper pipe thins over time until a pinhole leak becomes a rupture.
- High water pressure: pressure above about 80 psi stresses pipes, fittings and appliance hoses.
- Ground movement: shifting soil can break buried water service lines.
- Failed supply hoses: washer, toilet and faucet supply lines wear out and burst without warning.
How to prevent the next burst pipe
- Insulate pipes in unheated spaces and keep the heat at 55°F or higher when you're away in winter.
- Disconnect hoses and drain outdoor spigots before the first freeze.
- Install a pressure regulator if your pressure is too high.
- Replace rubber washer and toilet supply hoses with braided stainless lines.
- Watch your water bill — an unexplained increase can mean a hidden leak. Professional leak detection finds it before it bursts.
- If you have a basement, keep a working sump pump with a battery backup.
A burst near the water heater? Have the unit inspected too — our water heater service can check for damage to valves and connections.